The electrical characteristics of the vertical plug-in board type-c16p female base are as follows:

1. Material and electroplating:

2. Electrical performance:

2.1 Contact resistance: 30m Ω Max FOR INITIAL

40m Ω Max AFTER TEST

2.2 Withstand voltage: 100V AC

2.3 Insulation: 100M Ω Min

2.4 Rated current:

COLLECTIVELY VBUS PIN (A4, A9, B4, B9), Total 5A

VCCON PIN (B5) THROUGH GND PIN (A1, A12, B1, B12), 1.25A

Others PIN, 0.25A

2.5 Working temperature: -30 ° C to 80 ° C

3. Mechanical properties:

3.1 Insertion force: 5-20N

3.2 Pullout force: initial value 8-20N, after testing, 6-20N

3.3 Life: 10000 Cycles

4. Others

4.1 Pin needles must not have bending or deformation

4.2 Environmental requirements: Environmental material management regulations

4.3 This product complies with the reflow soldering process (once): 260 ° C ± 5 °, 10 seconds

5. Meet solderability: over 95% of the tin eating area

The characteristic of the vertical plug-in board type-c16p mother seat product is that it does not have a hardware shell and adopts a plastic tongue body with a base in structure. It belongs to the fully plastic type-c16p mother seat specification product. This type of product uses a digital finished machine plastic shell or hardware shell as the interface guide, which can visually simplify the appearance ID design style of the equipment product. In addition, the machine shell is usually formed by integrated injection molding or hardware die-casting, So this design can greatly reduce the tolerance of interface dimensions. In terms of material used in the product: the main tongue of the plastic body is environmentally friendly and high-temperature resistant plastic, the base material of the 16 pin pin pin is copper alloy, the terminal is nickel plated, the contact end is nickel plated, the solder plate end is tin plated, and the middle clip (medium steel sheet) inside the tongue is high-strength stainless steel material. In terms of product appearance specifications and size data: the main height (on board height) is 9.9mm (at the end of the tongue), the plastic base size is 12mm * 4mm, and the bottom is equipped with double plastic positioning columns (staggered and symmetrical). The column diameter is 1.0mm, and the 16pin pins are arranged in an 8-8 symmetrical double row manner. The soldering method is in a vertical straight insertion DIP form.